1" Thick (21 mm) Laser Cut Acrylic Letters

Mounting options and pricing

Price listed above

Plain letters are shipped without any mounting hardware. Recommended by dimensionalLetters.com for customers that will be installing their own two-sided foam tape or just using silicone to attach to project.

Add 5% to Price listed above

Studs are metal threaded posts on the rear of the letters. Specify if studs need to be in line for brick or block wall mortar joints. When installed, studs typically extend approx. 1-1/2"-2" from the back of the letters. (Brick: 2-5/8" on center; Block: 8" on center)

Add 5% to Price listed above

Pads are plastic disks on the rear of the letters. Adjustable or flush pads available upon request.

Add 5% to Price listed above

Combination has pads at the bottom and studs through pads at the top of the letter. Specify if studs need to be in line for brick or block wall mortar joints. Not for letters under 6". This type of mounting is recommended by dimensionalLetters because the installation of the 1" Plastic letters requires only holes to be drilled for the top half of the letter.

Add 5% to Price listed above

Combination All has studs through pads on all mounts. Specify if studs need to be in line for brick or block wall mortar joints. Not for letters under 6".

Add 5% to Price listed above

Strips of 3M-VHB (Very High Bond acrylic foam closed cell double-coated pressure sensitive adhesive tape) tape are placed strategically on the back of the 1 inch dimensional wall letters. Follow 3M recommendations for use. Not suitable for all mounting surfaces. surface preparation

Add 25% to Price listed above

Letters/logos 3/8" and thicker can be drilled and tapped to receive studs. Studs are metal threaded posts on the rear of the letters. Specify if studs need to be in line for brick or block wall mortar joints. When installed, studs typically extend approx. 1-1/2"-2" from the back of the letters. (Brick: 2-5/8" on center; Block: 8" on center)